Starter Vape Kit coil supply workbook guide
Ordering starter vape kit is not difficult. Ordering starter vape kit that sell through without a return queue behind them is the part most buyers underestimate, and it is where we spend our time. We supply vape shop owners in European and North American markets with core lines that turn over predictably, and we keep the specification list short enough for your team to actually manage.
Published 19 September 2026 · VapeWholesaleHub · Reading time 7 min
Building an assortment that actually turns
A starter vape kit programme only works when three numbers agree: your shelf price, your reorder cycle and your defect tolerance. Change one and the plan moves. We build assortments around those three and we say so up front rather than after the invoice.
When you compare suppliers for starter vape kit, ask for the last three production dates on the same SKU. If the answers are vague, the specification is not being held and the next batch will not match the sample you approved.
We source starter vape kits from a small group of factories we have worked with for years. That means a specification can be held across repeat orders instead of being re-qualified from scratch every quarter. Consistency is a boring selling point and it is also the entire game.
Merchandising a small range well
Seasonality in starter vape kits is real but smaller than most buyers assume. The bigger swing comes from restocking discipline, not from calendar events.
Bundle a device with a consumable and the reorder rhythm changes from occasional to weekly. That single merchandising decision often does more for monthly revenue than a price promotion.
What we test before a carton is sealed
Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.
Cosmetic grading is written down, not argued about. Minor scuffs inside the tolerance band are accepted; anything that would make a customer put the unit back on the shelf is rejected. Your staff should never have to explain a finish defect to a paying customer.
- Consolidated or split shipping, quoted both ways
- Document pack prepared per destination market
- Batch codes traceable from carton back to production date
- Specification locked in writing before production starts
- Mixed SKU cartons to spread first-order risk
- Cartons drop-tested and pallet-counted for clean freight
Unit price versus landed cost
We publish a realistic band of 2.96 to 8.84 per unit for standard configurations at 200 units. Below that band you are buying a lighter specification; above it you are paying for finish, packaging or a smaller run.
Payment terms for new accounts are normally a deposit with the balance against the bill of lading. Established buyers on a repeat schedule can move to terms after three clean shipments.
Specification summary
| Battery | 350 mAh |
| Pod capacity | 2.5 ml |
| Coil resistance | 1.2 ohm |
| Included | Device, 2 pods, cable |
| Charging | USB-C 5V/1A |
| Packaging | Blister pack |
| Minimum order | 50 units per SKU, mixed cartons allowed |
| Lead time | 22 working days after artwork approval |
If any of this is unclear, the fastest route is a message rather than a meeting. Send the market you sell into and the price band you work in, and you will get a specific answer instead of a brochure.
Frequently asked
What is the minimum order for starter vape kit?
Standard configurations start at 200 units per SKU, with mixed SKUs allowed inside the same carton. Custom colours, custom packaging or a private label run usually start at 500 units because of setup time on the line.
What happens if part of the order is defective?
Report within seven days with photos and the batch code. Confirmed defects are replaced or credited on the next shipment. The failure is logged by mode and batch, and reviewed monthly with the factory.
Do you support private label?
We do. Send your artwork or your brand direction and we will return a digital proof, then a physical dummy for colour approval. Packaging files stay on record so a rebrand later is a file update rather than a redesign.
Related reading
Need a quotation on starter vape kits?
Send destination market, target price and quantity. Same-day reply on working days.
Tel / WeChat / WhatsApp +86 13711127975 · vape@0099933.xyz